35 Whelen Recoil

Those considering the purchase of a 35 Whelen often express concern about recoil.  How does the 35 Whelen compare to the 30-06, or the 338 Winchester Magnum, or the 300 Winchester Magnum?

Reading online forums isn't helpful because every possible answer to these questions comes forth.  I've even read comments from participants who suggest the Whelen kicks as hard as the 9.3 x 62; but of course upon questioning them, one finds out that these individuals haven't ever owned a Whelen.

I'll share with you my experience with 35 Whelen recoil and compare it to cartridges and rifles I am familiar with. This is not a scientific comparison by any means; just a comparison based on that good'ol fashion thing called experience.

My current Whelen is a Remington 700 Classic in the original wood stock.  The recoil pad is original, and in my opinion more than ample. The barrel is 22" in length with a 1:16 twist.  I have free floated the barrel and epoxy bedded the action.

In order to make my comments a bit more relevant and accurate I will only consider factory ammunition in my comparisons.  I will be comparing the Whelen shooting 225 grain Nosler Accubond factory ammunition and Remington 250 grain PSP Ammunition.

The rifles which I'm going to compare the 35 Whelen to are firearms I have owned and fired a lot.  These include a Weatherby Mark V in 300 Win Mag (wood stock); a Browning A Bolt 7mm Rem Mag (synthetic stock); a Browning A Bolt II in 7mm Rem Mag (wooden stock); a Remington 700 BDL in 30-06; and a Sako Hunter in 338 Win Mag with KDF muzzle break. All of these rifles had decent recoil pads, including the 700 BDL onto which I had attached a Packmayr Decelorator.

  • Weatherby Mark V in 300 Win Mag (Wood Stock) using factory 180 grain ammunition definitely recoils sharper than the Whelen.  This, despite the fact that the Weatherby Mark V has a Monte Carlo stock and more weight. Even the Remington 250 grain Whelen loads kick less than the Weatherby. 
  • Browning A Bolt and Browning A Bolt II in 7mm Rem Mag using 150 grain ammuniton both recoiled more sharply than my 35 Whelen.  In fact, both rifles compared very closely to the Weatherby Mark V.  The synthetic stock A Bolt recoiled harder than the Weatherby Mark V.  The Whelen delivered less recoil ... hands down. 
  • Remington 700 BDL in 30-06 using 180 grain ammunition delivered very similar recoil to my 35 Whelen.  I found that 180 grain Remington Core Lokt ammunition kicked more sharply, but with less "push" than the Whelen.  Whelen 250 grain Remington Core Lokt ammunition delivered more "push" but with less sharpness.  It was almost as if recoil was delivered over a fraction of a second longer ... if that makes sense. 
  • Sako Hunter in 338 Win Mag shooting 225 grain ammunition gave the greatest recoil, hands down, even with the muzzle break.  None of the above rifles kicked as hard, in either sharpness or overall push. 
I have worked up reloaded ammunition that had the 35 Whelen kicking every bit as hard as the Mark V 300 Win Mag, but it took maximum powder charges and 225 grain TSX bullets to do so.  I didn't use these hot loads for hunting though, as they were inaccurate in my rifle.

I'm not sure why my 35 Whelen recoils about the same as my 700 BDL 30-06.  Logic would suggest that the heavier 35 caliber bullets would cause more recoil.  It could be that the reduced shoulder  on the Whelen works to mitigate recoil.  The result though, for whatever reason, is that my 35 Whelen gives 30-06 type recoil.

It is when reloading that the 35 Whelen comes into it's own. It can be pushed close to 338 Win Mag stopping power out to 300 yards but with considerably less recoil.  If your Whelen likes 250 Grain Nosler Partition bullets, you'll have a 300 yard moose and elk killer without the punishing recoil of the 338 Win Mag, but with comparable trajectory and power. 

For those who may be concerned about 35 Whelen recoil, let me make it simple.  If you handle 30-06 recoil well, you will handle 35 Whelen recoil well. 

No comments:

Post a Comment